FingerTec TA100 DIY - Manual (Page 37)

33
TO GENERATE AND SAVE REPORT
FingerTec® TA100 DIY prepares time attendance reports directly.
There are 3 reports available as explained below:
ELECTRONIC TIME CARD
Electronic Time Card is a complete attendance report for each user. All Check Ins, Breaks,
Resumes and Out times are displayed in this time card. If there were OT works involved, OT
and Done time would be printed too. The data displays day-by-day and normally presented
in a month format. Important information can be found printed in the report, including work
time, OT time, Late time and etc.
DAILY ATTENDANCE LISTING
Daily Attendance Listing report is intended to show all clocking activities of users for each
day. The data will be arranged and displayed by date and time.
STAFF MOVEMENT ANALYSIS
Staff Movement Analysis is to show users’ clocking data by terminals. Ignore this report if
you only installed one terminal. Installation of multiple terminals to capture clocking activi-
ties enables you to download clocking data from each terminal and upload them into a
master terminal. With all clocking activities from all terminals, you can print this report to
check terminals which were used for verifications. Please refer to page 38 to see download
and upload attendance data.
You can export and save these reports into a USB flash disk. Plug the USB flash disk into
a computer to view these reports. Reports can be viewed via Internet browser (Internet Ex-
plorer or Mozilla Firefox). You can print these reports directly.