E-MU Tracker Pre USB 2.0 - Manual (Page 51)

Technical Specifications
TRACKERpre Reference Manual 51
TECHNICAL SPECIFICATIONS
General
Sample Rates: 44.1, 48, 88.2, 96, 176.4, 192kHz from internal crystal with no
sample rate conversion
(Note: 176.4k & 192k sample rates not supported on Macintosh)
Bit Depth: 24-bit I/O, 32-bit processing
USB 2.0 Hi-Speed
Full 24-bit resolution at all sample rates
2 input and 2 output channels
Zero-latency direct hardware monitoring (disabled at 176.4/192kHz)
ASIO2, WDM MME, Apple Core Audio and Core MIDI drivers
Anti-Pop speaker protection minimizes noise during power on/off
Ultra-low jitter clock subsystem: <100ps RMS
Combo Microphone Preamplifier/Hi-Z/Line Input (2)
Type: Balanced combo mic preamplifier and Hi-Z/line input
A/D converter: AK5385
Phantom Power: Phantom-Z™ bus powered, E-MU CurrentMorph™,
(patent-pending)
Microphone Input
Type: Balanced
Input Impedance: 1.5 K Ohms
Max Level: balanced: +6.4dBV; unbalanced: +8.6dBu
EIN: (20Hz-20kHz, 150ohm, unweighted) -127dBu
Signal-to-Noise Ratio: (A-weighted, min. gain) 112dB
THD+N: (1kHz at -1dBFS, min. gain) -102dB (.0007%)
Gain Range: +60dB
Frequency Response: (min. gain, 20Hz-20kHz) +0.0/-0.03dB
Stereo Crosstalk: (1kHz min. gain, -1dBFS) < -111dB
Hi-Z Input
Type: Balanced (can be used with unbalanced cables)
Input Impedance: 1M ohms
Max Level: balanced: +6.9dBV; unbalanced: +9.1dBu)
Dynamic Range: -113dB
Signal-to-Noise Ratio: (A-weighted, min. gain) -108dB
THD+N: (1kHz at -1dBFS, min. gain) -102dB (.0007%)