Comtrol ES8508 Series User Guide - Manual (Page 178)

178 - Security (CLI) RocketLinx ES8508 Series User Guide: 2000575 Rev. A
Configuration Using the Command Line Interface (CLI)
Security (CLI)
The ES8508 provides several security features for you to secure your connection.
Optionally, you can use the web user interface for configuration, see Security on Page 110.
This table provides information about the command lines for security configuration.
Port Security
Add MAC
Switch(config)# mac-address-table static 00c0.4e3A.0101 vlan 1
interface fa1
mac-address-table unicast static set ok!
Port Security
Switch(config)# interface fa1
Switch(config-if)# switchport port-security
Disables new MAC addresses learning and aging activities!
Rule: Add the static MAC, VLAN and Port binding first, then enable the port security
to stop new MAC learning.
Disable Port
Security Switch(config-if)# no switchport port-security
Enable new MAC addresses learning and aging activities!
Display
Switch# show mac-address-table static
Destination Address Address Type Vlan Destination Port
------------------- --------------- ------- -----------------
00c0.4e3A.0101 Static 1 fa1
IP Security
IP Security
Switch(config)# ip security
Set ip security enable ok.
Switch(config)# ip security host 192.168.250.33
Add ip security host 192.168.250.33 ok.
Display
Switch# show ip security
ip security is enabled
ip security host:
192.168.250.33