beautypg.com

Toshiba MA-1050-100 Series User Manual

Page 90

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

When the receipt and journal print is too

light, replace the ink ribbon in the

following manner.

Removing the Ribbon

1. Turn the Power Switch to OFF.

2. Remove the Ribbon Cover. Press the side

inward and the hook will unlocked (Fig.l^t),

3. Open the Cutter Block by pulling it upward

while pressing the leftside lever outward.

(Fig. 15 and Fig. 16)

4. Remove the Ink Ribbon by lifting up the

ribbon spools (Fig. 17).

Installing the Ribbon

1. Set the ribbon spools so that the ribbon

will be wound to the directions shown by

the arrows respectively. Meanwhile, let

the ribbon go through the Ribbon Guides,

the Tension, and the Dot Head Ribbon Guide

(Fig,18 and Fig.19).

2. After setting, make sure that the ribbon

properly goes through each required parts

by turning a ribbon spool several turns.

3. Close the Cutter Block. Make sure that

the leftside lever has locked the block.

4. Turn the Power Switch to ON,

5. Depress

key. The flashing display

will stop and be lit steadily,

6. Attach the Ribbon Cover.

REPLACING THE INK RIBBON

Ribbon

Fig. 18

- 86 -

This manual is related to the following products: