Toshiba MA-1050-100 Series - Manual (Page 62)

CONDITION: Any time outside a sale
OPERATION; Mode Lock: SET
PRINT LINE ITEM NAME PROGRAMMING OR CHANGING
for another Item Name
lio! E
r
Code for the Print Line Item] |ST j —
(See the table on the
next page.)
Repeat for the next character.
regular-sized
character
—»S'
one double-sized
character
■^1 Character Code | ■»[?] -Lj ST |
(2 or 3 digits;
see the table
on page 72. )
Repeat
■ I AT/TLi
for spacing instead
of a character
Entire name with
all double-sized
characters
to end the name
(If any space is
left unprogrammed
in the tail, it
will automat ica1ly
be programmed as
space.)
NOTES: 1. See the "Max.Number of Characters" co lumn of the table on the
next page as to the number of characters programmable for each
item name. The number in the column indicates the capacity in
regular-sized characters. One double-sized character occupies
two regular-sized characters' space.
2. To go on to another Item name programming, the sequence "|Code
for the Print Line Item} fsT]" may be skipped if the code is
sequencial. In this case, follow the line marked with .
ex.) To program "TL" (both double-sized) for Item Code 3 (Total):
Mode Lock to SET, enter 10, depress [X ].
Enter 3, depress
I
ST
I
. (Item Code)
Depress [x] twice.
Enter 30, depress .
Enter 22, depress [71 .
Depress
I
ST
I .
Depress i~AT/TL 1 (to end this program).
NOTE: If Item Code 3 is not programmed with
"TL" in the above operation example,
the standard print data "TOTAL" (all
regular-sized characters) should have
been alive.
n
-1
THANK YOU
05-17-83 »0
P 10
»03 TL
0028 13:58
- 58 -