Toshiba MA-1050-100 Series - Manual (Page 83)

REMOTE SLIP PRINTER OPERATION
The TEC Remote Slip Printer DRS-103 may be connected to the MA-1050-100 series
ECR as an optional device. The Remote Slip Printer will operate printing if
a slip is properly inserted.
1. The remote slip printer will automatically activate printing when the slip
is properly set to the printer table.
2. No selection is provided for remote slip print compulsory status.
3. The following are the optional selections available if the remote slip
printer is connected:
1) Printing Position
Address #10 Bit 1:
RESET (standard): Prints every item on the right side of
the slip.
SET (option): Prints items of Departments, PLUs, 7«+, 7o-,
and Dollar Discount on the left side of the
slip. Other items will be printed on the
right side.
4. The gap of the slip inlet is usually opened, and the slip may be Inserted
or withdrawn freely.
When a slip is properly set to the remote slip printer and the ECR is
operated, the gap will be closed and printing will be performed. When
the sale is finalized, the receipt is issued and then the gap of the
DRS-103 will be opened to allow the slip withdrawn 1. (The gap keeps
closed during registration.)
5. Printing on the remote slip will be performed alternately with printing
on the receipt/journal on the ECR.
6. The EJECT Key on the DRS-103 may be used to open the closed gap in order
to withdraw the slip and skip unnecessary item print. The EJECT key will
be disregarded if the slip is set and the ECR receipt/journal printer is
in a printing action.
- 79 -