Toshiba MA-1050-100 Series - Manual (Page 71)

CONDITION: Any time outside a sale
OPERATION:
COMMERCIAL MESSAGE PROGRAMMING
r
Mode Lock : MGR SET I Line No, i 1 ST I —
Cl ~ 3)
Repeat for the next character.
regular-sized
character
-------- B-
One double-sized
character
•[SII]'
"^1 Character Code |-» IW \—» ! ST |
(2 or 3 digits;
see the table
on page 72 , )
Repeat
for the
next line.
AT/TL
for spacing instead
of a character
to end each line
(If any space is left
unprogrammed, it will
automatically be pro­
grammed as space.)
Entire line with all
double-sized characters
NOTES: 1. The key after the Character Code entry may be replaced by
the ¡#/CID| or r#7NSl key.
2. For one line, a maximum of 16 regular-sized characters or
8 double-sized characters may be entered. A combination of both
types is also available.
3. If no commercia 1 message is required on the receipt, program
all space for all the three lines. Then no message will be
printed and no extra line space will be fed. If any one of the
three lines is ever programmed, the two other lines will remain
programmed with space and will turn out to be estra space lines
to be fed on the receipt.
ex.) To program "THANK YOU" on the second
line. The first and third lines will
be space:
Mode Lock to MGR> enter 1, depress
I
SET|.
Enter 2, depress |ST 1 (line No.)•
Depress three times (for spacing).
Enter 30, depress [J] (T).
Enter 18, depress (H).
Enter 11, depress (A).
Enter 24, depress [J] (N).
Enter 21, depress [|] (K).
Depress . (space)
Depress [^. (space)
Enter 35, depress [J] (Y).
Enter 25, depress [S (0).
Enter 31, depress ¡T] (U).
Depress IST] (to end the line).
Depress F a T/TL \ (to end this program).
- 67 -