Toshiba MA-1050-100 Series - Manual (Page 39)

CONDITION; After Auto Reset and GT Reset
OPERATION:
SYSTEM OPTION PROGRAMMING
Enter a maximum of eight-digit number composed of Bit Nos whose
status must be set C o the "SET" status. If there is no Bit No.
t o b e set to the "SET" status in the Address No., enter "0".
ex.) To set Bit No*2 only .......... Enter 2.
To set Bits No.2 and No.3 ..... Enter 23.
To set all the Bit Nos ........ Enter 12345678.
To reset all the Bit Nos ...... Enter 0.
NOTES: 1. Any Bit No. with the "—vacant—" item will be disregarded even
if it is set. (However, if ever set, it will not result in an
error. )■
2. When the product was delivered to the customer, each Address
# had already been set with proper Option Nos according to the
cutomer's requirements. Therefore, it is recommended to read
out the programmed data of the SYSTEM OPTION first (refer to
page 78 ) and next do this programming operation only for the
Addresses that require option changes.
ex.) To select the following options in Address #1:
(Refer to the SYSTEM OPTION TABLE of Address #l
o n t h e f o l l o w i n g p a g e . )
Time Non-print (Bit No.l to "SET" status)
Item Count Print (Bit No.2 to "RESET" status)
Subtotal Non-print ( B i t No.3 to "SET" status)
PLU Total Amounts on PLU Reports Print
( B i t No.4 to "RESET" status)
Customer Counts of Departments on Reports Print
(Bit No.5 to "RESET" status)
OPERATION: Mode Lock to SET
11 iZI 1 [H] 13 [Z
I AT/TL
Prog.
No.
Opt ion Nos
for "SET" status
- 35 -