Toshiba MA-1050-100 Series User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CONDITION:
After an Auto Reset and GT Reset
OPERATION:
Mode Lock: SET
TAX TABLE PROGRAMMING
1) Tax 1 Full Breaks
I max. amount non-taxablej ^ ITXl/М]
1 max. amount for
\ i
tax levied| -> 1 TXl /МI
max. amount for 2¿ tax levied! -> j TXl /М
Repeat until the "A" Break is entered.
шд
(to indicate
the "A" Break entry)
max. amount
for N + lii
tax
levied 1
ITXI/Ml
max. amount
for N^2(i tax levied( -> 1
tx
T7
m
'I
Repeat unt i1
the "B" Break is
entered.
IAT/TLI (to end)
NOTE: The amount entry may be a maximum of 4-digit value (9999^),
2) Tax 1 "A” Break and T. Rate Combination
First set the "A” Break following the same operation up to the "A"
Break entry and the I ST 1 depression in the above
"1) Tax 1 Full
Breaks".
|
I RATE applied when exceeding the "A" Break amount |
(Maximum 4 digits, up to 99.99%. Do not use the [T] key. Example:
To set 5%, enter 500, The fraction of the amount resulting from
this
%
rate calculation will be rounded off.)
IAT/TLI (to end)
Tax 1 7o Rate Only
|o(
1 TXl/Ml
TAX RATE [AT/TL
(The conditions of the rate are the same as
the above TAX RATE.)
- 64 -