Toshiba MA-1050-100 Series - Manual (Page 59)

CONDITION: After an Auto Reset
OPERATION: Mode Lock: SET
DEPARTMENT LISTING CAPACITY SETTING
8 | -» E]
8| -» Ul
HALC
HALC
Repeat for each
department.
AT/TLI ... for the common listing
capacity for all the
___ Apartments
AT/TLI ... for individual
departments' listing
capac i t ies
DEFT
The above two operations may be combined as below:
ffl . -------------------------
8 HALC for the fOEPTl -r>
*
HALC common
individua I for all
department departments
AT/TL
Repeat for each
department.
*Note: HALC .... High Amount Listing Capacity (to be set in a 2-digit code)
I I I
-Number of maximum digits allowed
-Maximum value of the top digit allowed
ex. ) indicates 3999
4 d i g i t s---------
—Value of the
top digit
The amount range allowed to
enter will be:
Equal to or smaller than
the HALC (3999 in this case.)
NOTES: 1 If the individual listing capacity
of a department has been set, it
prevails over the common listing
capacity.
2. To reset an individual department
listing capacity, enter "0" before
the I DEPT [ key in the above opera­
tion. Then the common listing
capacity of all the departments,
i f pre-programmed, will prevail.
The common listing capacity may
also be reset if "0" is entered
as the HALC in the above operation.
ex.) To set HALC's: $9.99 for Dept.l
$99.99 for Dept.2
$99,999.99 as common L.C.
OPERATION: (Mode Lock: SET)
8 [T] 93 Г р ЕРТ 1 I 94 I DEPT 2| 97 [~ÄT/TL
- 55 -