Read(x) and reset(z) reports – Toshiba MA-1050-100 Series User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
READ(X) AND RESET(Z) REPORTS
The following table shows the key operation to take each report. The
"X" and "Z" reports have exactly the same content print if both are available,
except that:
1. The "X" reports allow to read the totals but not clear memories, while
the "Z" reports allow to read the totals and at the same time all
the resettable memories will be cleared when the reports have been
issued,
2. The symbol
"X" is
printed on the top line of a "X" report, while "2"
is printed on a "Z" report, to indicate the type of report.
3. A reset count is printed on the bottom of a "Z" report only.
TABLE OF OPERATIONS FOR X AND Z REPORTS
REPORT NAME
KEY OPERATION
AUTO READ REPORT *
AUTO RESET REPORT *
PLU READ REPORT
PLU RESET REPORT
Mode Lock:
X ,
Mode Lock: Z —' ------
HOURLY READ REPORT
HOURLY RESET REPORT
uoi^iAizia
IN-DRAWER READ REPORT
Mode Lock; X or #/ClD1 or!#/NS1
GT READ REPORT *
GT RESET REPORT *
Mode Lock: any position
GT Lock:
GTX
GT Lock: GTZ —^ ■-*
PRESET DATA VERIFICATION
Mode Lock: X
, Department Preset Prices
1.11 ^ mi
. Department Listing Capacities,
Tax Status, Positive/Negative
12| ^ [H]
. PLU Codes, Preset Prices, Linked'
Departments
i l l ^ H I ]
. 7o+, 7o- Preset Rates, Al 1 Depart
ments' Common Listing Capacity
HI -> H
i
]
. Customer System Option Selection
15! ^ [H)
NOTES: 1) Usually, the cash drawer will open on the depression of the 1AT/TL1
for the reports marked with . However, it will not open if so
programmed in the system option,
2) No Clerk Key is necessary to inssue any of the reports.
3) Refer to the report samples on the following pages. As for the
PRESET DATA VERIFICATION print samples, see the "VERIFICATION OF
PROGRAMMED DATA" near the end of this manual.
- 28 -