Toshiba MA-1050-100 Series - Manual (Page 12)

VAL I
DATE Validation Key
This key is used to print a validation slip.
To operate, after registering the required item, insert a slip into
the validation slot and depress the |VALIDATE 1 key. The item and
the amount will be printed on the slip.
The system option provides program selections as to single- or multi­
validation, validation compulsion on certain transaction keys, print/
non-print of date and/or consecutive No., etc.
If validation is performed after a single-item department entry, the
sale amount with tax is printed on the validation slip. However,
if validation is performed after a single-item department entry with
a validation compulsory status (e.g., the 1RTN1 key with validation
compulsory status set has been depressed prior to the single-item
entry), the total without tax is printed on the validation slip.
I RFI Receipt Feed Key
This key is used to advance the receipt roll. It is operated by
depressing the key and holding it in that position until the paper
has advanced to the required position.
The receipt roll can be advanced even when the I RECEIPT ON/OFF] switch
is in the OFF position. Receipt feeding during a sale is ususally
allowed, but it can be programmed to be prohibited.
IJF1 Journal Feed Key
This key is used to advance the audit roll in the same fashion as
the RF key. This key is useful if the cashier, due perhaps to an
interruption whilst ringing up a sale, is unsure which items have
already been entered. By using this key, the cashier can see which
figures have actually been printed.
The RF and JF keys can not be operated simultaneously.
Clear Key
This key is used to correct a numeric entry error if prior to depress­
ing any other key, or to correct any error condition and cancel the
alarm buzzer.
If the key is depressed after a sub-total is obtained, the sub­
total is then displayed. If depressed after a taxable total is
obtained, the taxable total is then displayed.
The key is also effective to clear the tax-modified' status on
a preset department entry being repeated. For example, to enter two
items of the same department with taxable/non-taxable status modified
from the original status, and then one item with the original status,
Operate: | TX/M1-».rDE^•
- 8 -