2. connection, 2-1. precautions, 2-2. fixed station – Kenwood TM-3530A User Manual
Page 8: 2-1. precautions 3-2-2. fixed station
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
© Lift the lever.
© The angle of the bracket may
be adjusted to any of 5 possi
ble viewing angles by loosen
ing the 4 alien bolts at the
top of the bracket using the
hex wrench provided.
After the desired angle has
been selected tighten the 4
bolts.
©
1
@11
®
1
V
____________
©
Carefully slide the transceiver
into the mounting bracket.
(a)
© By installing a lock thru the
keyhole on the side of the
mounting bracket, the lever
can be locked and the trans
ceiver secured.
cure the transceiver.
(b)
Fig. 3-3
3-2. CONNECTION
3-2-1. Precautions
1. When connecting or disconnecting the power cable to
or from the power connector, be sure to turn off the
POWER switches of the transceiver and the DC power
supply.
2. Observe polarity of the cable. The transceiver oper
ates on 13.8 VDC, negative ground. Battery polarity
must be correct. The power cable is color coded.:
Red and white : © polarity (Positive)
Black and gray : © polarity (Negative)
3. The standard operating voltage of the equipment is
13.8V. Do not operate below 12V or over 16V.
4. When charging your vehicle battery, or when jump-
starting a dead battery, ALWAYS disconnect the
power cable from the back of the transceiver, or da
mage may result to the transceiver.
3-2-2. Fixed station
A regulated DC power supply (13.8 VDC) is required. The PS-430 is recommended for TM-3530A/2550A/2550E/2530A.
The PS-50 is recommended for the TM-2570A.