5-2. programmable band-scan from the keyboard, 5-3. scan direction, 5-4. scan speed – Kenwood TM-3530A User Manual
Page 18: 5-5. scan lockout (skip), 5-6. scan release
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4-5-2. Programmable band-scan from
the keyboard
The lower limit may be programmed into memory "d"
and the upper limit into memory "IJ”.
© Press the M.CH switch to select key mode. The
MEMORY CHANNEL selector lamp will go OFF.
© Press the |SC | key to initiate scan operation. If scan is
initiated within the limits set in channel " d " and “ U ",
scan will proceed from the currently displayed fre
quency (within the programmed limits), in 5 kHz
steps. If you initiate scan outside the programmed
limits, scan will proceed outside the programmed
limits, in 5 kHz steps.
@ When the same frequency has been stored in both
memory "d " and memory " U ". The radio will scan
the entire frequency range of the radio.
4-5-3. Scan direction
During scan operations you can reverse the direction of
scan with the UP and DWN pushbuttons on the micro
phone. Pressing the DWN key causes scan to proceed
down in frequency. Pressing the UP key causes scan to
increase in frequency.
4-5-4. Scan speed
Scan speed can be increased by holding either the UP or
the DWN key depressed, depending upon the desired di
rection of scan.
® Select the channel to 0 Set to memory
Lock out indicator be locked out. \______________mode.
0 A star ★ will appear on the ©When the |LO| key is pressed
display when this key is
again, the star ★ will disap-
pressed, indicating that
pear and lockout will be re
lockout has been complet- leased,
ed.
4-5-5. Scan lockout (Skip)
This transceiver has a scan lockout function which al
lows you to temporarily skip unwanted memory channels
during memory scan.
© Press the M.CH switch to select the memory mode.
(The MEMORY CHANNEL selector will light.)
© Select the memory channel to be skipped by using the
MEMORY CHANNEL selector.
© Press the |LO| key and a star ★ appears to the left of
the memory channel number.
® Repeat steps © and © to lockout any unwanted
memory channels.
To cancel channel lockout, select the memory channel
to be restored, and press the |LO| key. The star will
disappear.
4-5-6. Scan release
Scanning can be released by any one of the following
operations: Select the most convenient.
© Press the key.
© Press the PTT switch once.
© Turn power OFF.
© Set the PRIO switch to ON.
© Set the F.LOCK switch to ON.
18