Kenwood TM-3530A - Manual (Page 29)

To move to an open channel during communication be­
tween stations A and B at 146.520 MHz, proceed as fol­
lows. (In this example, 146.520 MHz is the frequency of
operation.)
The same procedure is used with the TM-3530A.
Example:
Initiating station : Station A
Waiting station : Station B
Digital code : 12345
Offset
: [S] (Simplex)
Memory CH A : 146.400 MHz
Station A Station B
1. Confirm the digital code.
Press the CS key to check that the digital code is
"12345", then press the CS key again.
1. Confirm the digital code.
Press the CS key to check that the digital code is
"1 2345", then press the CS key again.
UJ 03 [m
m no m
m m m
El m Bai-
□ n □ on
KENWOOD TM -25604
□ o o
CT E [□3
m m B3 Ei*
m m
im 1518°
2. Press the DCL key to switch the DCL system ON. 2. Press the DCL key to switch the DCL system ON.
KENWOOD TM-2550A |lE|
m
m
m
5°5G0
m E m
□aczia
|]3|;D MMMirwTMMrtutvti
E
[Uci '»¿U^TcHw
.offT
sot. i
□ ID □ DO i
B . S E G
□ o □ on
E
m mio3 !si-
e I e E3=I
3. Press the CHL key.
The CHL indicator flashes and a search for an open
channel begins.
(This example assumes that there is an open channel
at 146.430 MHz.)
3. Standby.
□ no DC
m E ICOim*
m m 03
P3 E El
E
E
□ n o o n
4. The original operating frequency (146.520 MHz) is se­
lected and data is transmitted automatically.
4. The transmit data of station A is received.
m 03 m EU*'
m ca m
roi R3 E
E mim
5. The radio QSY's to the open channel.
As the movement to the open channel (146.430 MHz)
occurs, the flashing CHL indicator lights continuously
and beep sound is generated to announce the comple­
tion of channel linkage.
5. The radio QSY's to the open channel.
As the movement to the open channel (146.430 MHz)
occurs, the CHL indicator lights continuously and
beep sound is generated to announce the completion
of channel linkage.
5 . W 3 G
CD m m ESI*
□3 m m lEn>
uO m
m
ra
SSI"
o n □ □
B . ^ 3 0 . . .
c
m 03 03 USD»
m m im
E col
CT
atsi"
m m 8S8"
29