Kenwood TM-3530A - Manual (Page 41)

7-3. VS-1 VOICE SYNTHESIZER UNIT
The operating frequency, DCL access code, call sign
data, or subaudible tone data may be easily recalled by
pressing the front panel VOICE switch.
Accessories:
1. Tapping screw.................. (N89-3006-46) 4 pcs.
2. Instruction manual.............(B50-4035-00).......... 1 copy
Installation procedure
Caution:
Before installation, be sure to disconnect the power cord,
or damage may occur to the voice unit or to the radio.
• Talk speed selection
Speed is factory set at "standard" talk speed. Three dif­
ferent speeds can be selected.
The place in which a jumper
wire to be placed.
Installation area
Speed
Jumpe^^-^^^^^
place
Std.
speed
30%
more than
Std.
60%
more than
Std.
1
X X O
2
X X O
3 X O X
Symbol (O) denotes the place in which a jumper wire is
placed.
Note:
When placing the jumper, solder carefully.
• Voice output level adjustment
Voice output level is factory adjusted. This level may be
readjusted with VR1 if desired.
0 Remove the four screws securing the top cover.
Note:
When removing the top cover, be careful not to da­
mage the speaker wires. You must unplug the
speaker cable.
(D Connect the 3-pin blue connector to the correspond­
ing blue jack onthe VS-1 as shown.
(D Connect the 8-pin plug of the cable harness to the
corresponding jack of the VS-1 as shown.
® Secure the VS-1 to the chassis with 3 of the supplied
self-tapping screws.
0 Reconnect the speaker wire, and replace the top cover
to complete the installation.
Notes:
• Language selector switch
Switch SI selects either the English (EN) or Japanese
(JA) language.
7-4. OTHER ACCESSORIES
■ PS-50 Heavy duty DC power supply
May be used with the TM-3530A/2570A/2550A/
2550E/2530A for stable operation.
■ PS-430 DC power supply
May be used with the TM-3530A/2550A/2550E/
2530A for stable operation. (Not for TM-2570A)
PS-430
41