Pioneer SUPER TUNERIII DEH-P8500MP - Manual (Page 42)

Section
№1 ( Initial Settings
Initially, the unit is setter rear full-range speak­
er connection (RearSP:FULL). When rear out­
put are connected to full range speakers
(when
Rear SP:FULL is selected), you can con­
nect the RCA subwoofer output to a subwoo­
fer. In this case, you can select whether to use
the subwoofer controller’s (low pass filter,
phase) built-in S.W ControhINT or the auxili­
ary S.W Control:EXT.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select Rear SP.
Press FUNCTION repeatedly until Rear SP ap­
pears in the display.
3 Press A or T to switch the rear output
setting.
Pressing A or T will switch between
Rear SP:FULL (full-range speaker) and
Rear SP:S.W (subwoofer) and that status will
be displayed.
■ When no subwoofer is connected to the rear
output, select Rear SP :FULL.
■ When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S.W.
■ When the rear output setting is RearSP:S.W,
you cannot change the subwoofer controiier.
4 Press ◄ or ► to switch the subwoofer
output or non fading output.
Pressing ◄ or ► will switch between
S.W ControhINT and S.W ControhEXT and
that status will be displayed.
Notes
Even if you change this setting, there is no
output unless you turn the non fading output
(refer to Using non fading output on page 37)
or subwoofer output (refer to Using subwoofer
output on page 37) in the audio menu on.
If you change the subwoofer controller, sub­
woofer output and non fading output in the
audio menu return to the factory settings.
Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.tZ)
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu­
ated automatically when a call is made or re­
ceived using a cellular telephone connected to
this unit.
• The sound is turned off, MUTE or ATT is
displayed and no audio adjustment is pos­
sible.
• Operation returns to normal when the
phone connection is ended.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select Telephone.
Press FUNCTION repeatedly until Telephone
appears in the display.
3 Press -4 or ► to switch the telephone
muting/attenuation.
Pressing ◄ or ► will switch between
Telephone :ATT (attenuation) and
Telephone :MUTE (muting) and that status
will be displayed. (E
Switching the motion screen
You can turn on or off the moving source icon
display. When off is selected, the moving
source icon disappears after opening screen
is displayed.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select Motion.
Press FUNCTION repeatedly until Motion ap­
pears in the display.
En