Pioneer SUPER TUNERIII DEH-P8500MP - Manual (Page 40)

Section
(Initial Settings
J C
Adjusting initial settings
lip) '
PWFl
/ oh A W
1 2 : 0 0
L. i - 1
©
Initial settings lets you perfornn initial set up ot
different settings for this unit.
© Function display
Shows the function status,
1 Press SOURCE and hold until the unit
turns off.
2 Press OPEN to open the front panel.
3 Press FUNCTION and hold until the
clock appears in the display.
4 Press FUNCTION to select one of the in­
itial settings.
Press FUNCTION repeatedly to switch be­
tween the following settings:
Clock— Warning (warning tone)— Flap Auto
(flap auto open)— AUX (auxiliary input)
—Dimmer (dimmer)— Brightness (bright­
ness)— Rear SP (rear output and subwoofer
controller)— ^Telephone (telephone)— Motion
(motion screen)
Use the following instructions to operate each
particular setting.
■ To cancel initial settings, press
BAND.
■ You can also cancel initial settings by holding
down FUNCTION until the unit turns off. S
Setting the clock
Use these instructions to set the clock.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select clock.
Press FUNCTION repeatedly until clock ap­
pears in the display.
3 Press ◄ or ► to select the segment of
the clock display you wish to set.
Pressing ◄ or ► will select one segment of the
clock display:
Hour—Minute
As you select segments of the clock display
the segment selected will blink.
.
2i>1 Oc
...........
O- t Y c
^
\o^
i. i -1
4 Press A or T to set the clock.
Pressing A will increase the selected hour or
minute. Pressing T will decrease the selected
hour or minute. 0
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select Warning.
Press FUNCTION repeatedly until Warning
appears in the display.
3 Press A or ▼ to turn Warning on or off.
Pressing A or ▼ will turn Warning on or off
and that status will be displayed (e.g..
Warning :ON).0
En