Pioneer SUPER TUNERIII DEH-P8500MP - Manual (Page 38)

Section
T (Audio Adjustments ^
C
3 Press A or T to adjust the output level
of the non fading.
Each press of A or T increases or decreases
the level of the non fading. + 6 --6 is displayed
as the level is increased or decreased. 0
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass tilter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 Press OPEN to open the front panel.
2 Press AUDIO to select HPF.
Press AUDIO until HPF appears in the display.
3 Press A to turn high pass filter on.
HPF 80 Hz appears in the display. High pass
filter is now on.
■ To turn high pass filter off, press T.
4 Press ◄ or ► to select cut-off frequency.
Each press of ◄ or ► selects cut-off frequen­
cies in the following order:
50—80—125 (Hz)
Only frequencies higher than those in the se­
lected range are output from the front or rear
speakers.
Note
If you switch the SFEO setting, the HPF function
is automatically turned off. By turning the HPF
function on after selecting the SFEO setting, you
can combine HPF function with SFEO
function. 0
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra­
dical changes in volume when switching be­
tween sources.
• Settings are based on the volume level of
the FM tuner, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad­
just.
2 Press OPEN to open the front panel.
3 Press AUDIO to select SLA.
Press AUDIO until SLA appears in the display.
4 Press A or T to adjust the source vo­
lume.
Each press of A or T increases or decreases
the source volume.
SLA +4- SLA-4 is displayed as the source vo­
lume is increased or decreased.
Notes
Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
The AM tuner volume level can also be ad­
justed with source level adjustments.
The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically .0
(M)
En