Pioneer SUPER TUNERIII DEH-P8500MP - Manual (Page 33)

Audio Adjustments
Section
m
Introduction of audio
adjustments
(D Audio display
Shows the audio adjustments status.
(D Preset equalizer indicator
Shows which equalizer preset is currently
selected.
d) ASL indicator
Shows when the automatic sound levelizer
is turned on.
1 Press OPEN to open the front panel.
2 Press AUDIO to display the audio func­
tion names.
Press AUDIO repeatedly to switch between
the following audio functions:
Fad (balance adjustment)— EQ (equalizer
curve adjustment)— Bass (bass)— ^Treble (tre­
ble)— Loud (loudness)— Sub-W1 (subwoofer
on/off setting)/NonFad (non fading output on/
off setting)— Sub-W2 (subwoofer setting)/
NonFad (non fading output setting)— HPF
(high pass filter)— SLA (source level adjust­
ment)— ASL (automatic sound levelizer)
■ When the subwoofer controller setting is only
S.W ControhEXT, you cannot switch to Sub-W1.
(Refer to page 41.)
■ You can select the
Sub-W2 only when sub­
woofer output is turned on in the Sub-W1.
■ When the subwoofer controller setting is only
S.W ControhEXT, you can switch to the non fad­
ing output on/off setting. (Refer to page 41.)
■ You can select the non fading output setting
only when non fading output is turned on in the
non fading output on/off setting.
■ When selecting the FM tuner as the source,
you cannot switch to SLA.
■ To return to the display of each source, press
BAND
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re­
turned to the source display. S
Setting the sound focus
equalizer (SFEQ)
Clarifying the sound image of vocals and in­
struments allows the simple staging of a nat­
ural, pleasant sound environment. Even
greater listening enjoyment will be obtained if
seating positions are chosen carefully.
FRT1
boosts the treble on the front output and the
bass on the rear output.
FRT2 boosts the treble
and the bass on the front output and the bass
on the rear output. (The bass boost is the
same for both front and rear.) For both
FRT1
and FRT2, H setting provides a more pro­
nounced effect than L setting.
1 Press EQ and hold until SFEQ appears in
the display.
2 Press EQ to select the desired SFEQ set­
ting.
Press EQ repeatedly to switch between the fol­
lowing settings:
FRT1-H (front 1-high)— FRT1-L (front 1-low)
—FRT2-H (front 2-high)— FRT2-L (front 2-low)
—CUSTOM (custom)— SFEQ OFF (off)
m
3
(O
En
(33)