Pioneer SUPER TUNERIII DEH-P8500MP - Manual (Page 36)

Section
Audio Adjustments C
2N—IN—1W—2W
Note
If you make adjustments when a curve other than
CUSTOM2 is selected, CUSTOM1 curve Is up­
dated.®
Adjusting bass
You can adjust the cut-off frequency and the
bass level,
• If SFEQ has been set to FRT1, bass adjust­
ment affects only the rear output: front out­
put cannot be adjusted.
1 Press OPEN to open the front panel.
2 Press AUDIO to select Bass.
Press AUDIO until Bass appears In the dis­
play.
3 Press ◄ or ► to select the desired fre­
quency.
Press ◄ or ► until the desired frequency ap­
pears in the display.
40—63—100—160 (Hz)
4 Press A or T to adjust the bass level.
Each press of A or T increases or decreases
the bass level. + 6 --6 is displayed as the level
is increased or decreased.®
Adjusting treble
You can adjust the cut-off frequency and the
treble level.
• If SFEQ has been set to FRT1 or FRT2, tre­
ble adjustment affects only the front out­
put: rear output cannot be adjusted.
1 Press OPEN to open the front panel.
2 Press AU DIO to select Treble.
Press AUDIO until Treble appears in the dis­
play.
3 Press ◄ or ► to select the desired fre­
quency.
Press ◄ or ► until the desired frequency ap­
pears in the display.
2.5k—4k—6.3k—10k (Hz)
4 Press A or T to adjust the treble level.
Each press of A or T increases or decreases
the treble level. +6 --6 is displayed as the
level is increased or decreased.®
Adjusting loudness
Loudness compensates for deficiencies In the
low- and high-sound ranges at low volume.
1 Press OPEN to open the front panel.
2 Press AUDIO to select Loud.
Press AUDIO until Loud appears in the dis­
play.
3 Press A to turn loudness on.
Loudness level (e.g., Loud Mid) appears in the
display.
4 Press -4 or P- to select a desired level.
Each press of ◄ or ► selects level in the fol­
lowing order:
Low (low)— Mid (mid)— Fligh (high)
5 Press T to turn loudness off.
Loud OFF
appears in the display.®
En