Bobbin winding, Bobbin windingpiisa, -22 – Kenmore 15343 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bobbin Winding
• Removing bobbin case
Remove the extension table from the machine by pulling
it to the left. Open the shuttle cover® by pulling down
the embossed part on the left of the cover.
Raise the needle to its highest position by rotating the
handwheel toward you.
® Shuttle cover
(2)
Bobbin case
To remove the bobbin case @from the shuttle, pull open
the latch of the bobbin case. Pull the bobbin case straight
out of the shuttle.
^5/
• Bobbin winding
rn Release the clutGh. by puiiingl out the handwheej,; This
will stop the nee;dl6:from moving while you wind the
bobbin.
] Draw thread from the spool.
] Guide the thread around the thread guide.
] Thread through the hole in the bobbin from the inside to
the outside.
] Put the bobbin on the bobbin winder spindle.
18