beautypg.com

Changing needle, To remove and attach the foot holder – Kenmore 15343 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Extension Table

• Detaching the table

Puil the table away from the machine, as illustrated, for

“free-arm” sewing of cuffs and sleeves. The extension
table can be used as accessory box.

• Attaching the table

Push the extension table until it snaps into the machine

(T) Extension table
(2) Pin
(3) Holes
©Tab

®

Free-arm

Changing Needle

CD

Needle clamp screw

(2) Needle clamp

|T| Turn off the power switch.

Raise the needle to its highest position by tj--; ng tos
handwheel counterclockwise. toward:you;, and lowering

the presserfoot. LoosfhThwneedle òlamp screw(D by
turning it counterclockwisey:. Remove the .needle frorh. the
needle clamp

''V

|T| Insert a new nei|Ìjiiinto the needle clamp ©with the

flat side to the 'iiiiiKiyVhen insertlpgille needle into the

needle clamp(|||j:(|ih it up as fdillBgoes. Tighten
the needle clamp.screw (T) firmlysii|ldrning it clockwise.

[3]To see if the needle is good, place^ the flat side of the

needle onto somethíhgíÍi|i|e;|;;lft^ plate or glass).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.

A damaged needle can cause permanent snags or runs

in knits, fine silks and silk-like fabrics.

To Remove and Attach the Foot Holder

® Set screw
(D Foot holder
(D Presser bar
• To remove

Remove the set screw ® by turning it counterclock­

wise with a screwdriver.

• To attach

Match the hole in the foot holder (

2

)

with the threaded

hole in the presser bar Fit the set screw ® into

the hole. Tighten the screw ® by turning it clockwise with
screwdriver.

10

This manual is related to the following products: