Cisco XM Universal Gateways Cisco AS5400XM - Manual (Page 89)

C-1
Cisco AS5400XM Universal Gateway Chassis Installation Guide
OL-6418-02
A P P E N D I X
C
Cabling Specifications
This appendix provides the following cabling and pinout information for the Cisco AS5400XM
universal gateway:
• Console and Auxiliary Port Cables and Pinouts, page C-1
• Ethernet Port Pinouts, page C-4
• BITS Cable and Port Pinouts, page C-5
• Alarm Port Pinouts, page C-5
• Bantam Jack Port Pinouts, page C-6
Note This appendix specifies pinouts only for the pins used. Pins not listed in the tables in this appendix are
not connected.
Console and Auxiliary Port Cables and Pinouts
The universal gateway arrives with a console and auxiliary cable kit, which contains the cable and
adapters you need to connect a console (an ASCII terminal or PC running terminal emulation software)
or modem to your universal gateway. The console and auxiliary cable kit includes:
• RJ-45-to-RJ-45 rollover cable. (See the next section, “ Identifying a Rollover Cable ,” for more
information.)
• RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL).
• RJ-45-to-DB-25 female DTE adapter (labeled TERMINAL).
• RJ-45-to-DB-25 male DCE adapter (labeled MODEM).
For console connections, proceed to the “Console Port Cables and Pinouts” section on page C-2 . For
modem connections, proceed to the “Auxiliary Port Signals and Pinouts” section on page C-4 .
Identifying a Rollover Cable
You can identify a rollover cable by comparing the two modular ends of the cable. When you hold the
cables side by side, with the tab at the back, the wire connected to the pin on the outside of the left plug
should be the same color as the wire connected to the pin on the outside of the right plug. (See