Cisco XM Universal Gateways Cisco AS5400XM - Manual (Page 23)

C H A P T E R
2-1
Cisco AS5400XM Universal Gateway Chassis Installation Guide
OL-6418-02
2
Preparing to Install
This chapter describes the tasks you must perform before you begin to install the universal gateway and
includes the following sections:
• Safety Recommendations, page 2-1
• Required Tools and Equipment, page 2-3
• Preparing to Connect to a Network, page 2-3
Safety Recommendations
Any device that uses electricity must be handled carefully; follow these guidelines to ensure general
safety:
• Keep the chassis area clear and dust-free during and after installation.
• Put the removed chassis cover in a safe place.
• Keep tools away from walk areas where you and others could fall over them.
• Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up
your sleeves.
• Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Maintaining Safety with Electricity
Warning Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. Statement 43
Follow these guidelines when you work on equipment powered by electricity.
• Locate the emergency power-OFF switch for the room in which you are working. Then, if an
electrical accident occurs, you can act quickly to turn OFF the power.