Connecting to the network, Figure 3-5 – Cisco XM Universal Gateways Cisco AS5400XM User Manual
Page 35
3-5
Cisco AS5400XM Universal Gateway Chassis Installation Guide
OL-6418-02
Chapter 3 Installing the Cisco AS5400XM Universal Gateway
Connecting to the Network
Figure 3-5
Attaching the Chassis to the 19-Inch Rack—Rear Panel Forward
Connecting to the Network
This section describes how to connect the Cisco AS5400XM universal gateway to your network. The
cables required to connect to a network are not provided. For ordering information, contact customer
service (see the
“Obtaining Technical Assistance” section on page xvi
) or see
for cable and port pinouts.
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Caution
If the Cisco AS5400XM universal gateway is configured with fewer than seven DFCs, make sure that a
blank slot cover is installed over each open slot to ensure proper airflow.
Note
The Cisco AS5400XM universal gateway arrives with all carrier cards and DFCs already installed,
unless you order a card separately as a spare. See the Cisco AS5350XM and Cisco AS5400XM Universal
Gateways Card Installation Guide for card installation instructions.
29034
Note: The second bracket attaches to the rack at the other side
of the chassis. The brackets can also be installed with the
front panel forward.