Carl Goldberg GBGA1064 - Manual (Page 21)

21
The wires should just be snug with no slop,
don’t distort the flying surfaces with
too much tension.
8. Pass the cable through the brass tube,
through the bracket on the stab and back
through the brass tube. Pull the cable tight,
but be careful not to put pressure on the stab
or fin. we want the cable to just be snug at this
point and we will adjust the tension after all
four are in place. Loop the cable back through
the brass tube again and crimp.
Repeat for the other four cables.
6. After all four flying wires are in place, adjust
the tension by disconnecting the clevis and
turning.
The Following is from the Carl
Goldberg Products Anniversary Cub
Booklet
1. Using glass cleaner and a soft cloth, clean the
model surface thoroughly before applying
decals.
2. Cut the decal sheets apart in sections, as
needed.
Fold the decal in half, front to rear. Open at
the fold and place the decal on a flat surface.
The protective backing will bubble away from
the decal at the fold.
DECAL APPLICATION
We have given you small “N” numbers to be
place on the rudder or you can use the larger “N”
numbers on the side of the fuselage if you choose.
If you choose to place the numbers on the
side you will have to remove the black stripe where
the number will rest. Remove the stripe by using a
iron set to 300 deg. and gently pulling the stripe up.
Once you have applied the number then you can
reapply the stripe using heat.