Carl Goldberg GBGA1064 User Manual
Page 19
19
5.
Attach the wing to the strut by screwing the
clevises in & out to the straps.
Caution:
Tighten the wing struts just enough
so that you do not have to “pull or
tug” to put the struts on or off the
wing and fuselage brackets.
Do not over tighten the struts they
can distort the wing.
RECEIVER, BATTERY & SWITCH
3.
Drill a hole in the bottom of the fuselage and
extend the receiver out to the tail.
Wrap the battery in foam and place it under or
just behind the fuel tank. After checking the
CG you can move the battery around to get
the right balance.
1.
Install your radio switch.
2.
Plug in your receiver. Make sure you wrap the
receiver in foam.
OPTIONAL FLYING WIRES
WE RECOMMEND THAT YOU USE FLYING
WIRES IF YOU WILL BE USING ANY ENGINE
LARGER THAN A .70 2 STROKE OR .91 4
STROKE
1. Locate the following parts
Roll of braided cable
(8) metal brackets (2 with one larger
holes)
(4) 2-56 rigging couplers
(4) golden clevis
(4) metal clevis retainers
(8) cable swages
(3) 2-56 x 1/2” screws
(3) 2-56 nuts
(3) #2 flat washers
(2) #2 x 1/2” sheet metal screws