Add 000 – A&D Weighing HC-3Ki User Manual
Page 17
15
Desired Sample Size Not Using The
SAMPLE
Key
1. The three
UNIT WEIGHT BY
LED’s should be blinking at this
point, if not, press the
RESET
key. to clear any unit weight. If you
are going to use a tare container, place it on the weighing pan and
press the
TARE
key. Be sure to set the weight display is “0”.
2. Place sample pieces on the
weighing pan (or in the tared
container).
The weight of the pieces will be
displayed.
3. Use the
0
Æ
9
10-key pad to
enter the sample size of the pieces
you placed.
If you hit the wrong key, press
the
C
key to clear and enter again.
(Example of setting a sample size of
20)
4. Press the
ENTER
key.
The display will show “-------” for a
moment while calculating the unit
weight. After a moment the display will
show the count, total weight and unit
weight.
If the “add ##” display appears on the
unit weight display, then the sample
size is not large enough for accurate
counting – add the additional number of
sample pieces.
5. You may now begin counting operations
for pieces of the same weight.
888.8.8.81
0
COUNT
WEIGHT UNIT WEIGHT
888
0.000
8
8
0.00000
0
00
If weight isn’t zero, press the TARE.
TARE
888.8.8.82
0
COUNT
WEIGHT UNIT WEIGHT
888
0.112
8
8
0.00000
0
00
888.8.8.8
20
COUNT
WEIGHT UNIT WEIGHT
888
0.112
8
8
add
000
Ñ
Blinking
Ò
ENTER
8
-------
COUNT
WEIGHT UNIT WEIGHT
888
0.112
8
8
add
000
888.8.8.8
20
COUNT
WEIGHT UNIT WEIGHT
888
0.112
8
8
5.61200