A&D Weighing HC-3Ki - Manual (Page 15)

13
5, 25, 50 or 100 Sample Size
1. The three UNIT WEIGHT BY LED’s should be blinking at this
point, if not, press the RESET key. to clear any unit weight. If you
are going to use a tare container, place it on the weighing pan.
2. Press the
SAMPLE key. Any tare
container will be automatically tared.
The display will show “add” “10 pcs”.
3. Press the
SAMPLE key to do
through the count size: of 5, 25, 50
or 100 pieces.
‰
The larger the sample size, the more
accurate unit weight registered.
(Example of selecting a sample size
of 50)
4. Place the selected number of
sample pieces on the weighing
pan (or in the tared container).
The weight of the pieces will be
displayed.
5. Press the
ENTER key.
The display will show “-------” for a
moment while calculating the unit
weight. After a moment the display will
show the count, total weight and unit
weight.
If the “add ##” appears on the unut
weight display, then the sample size is
not large enough for accurate counting
– add the additional number of sample
pieces.
6. You may now begin counting operations
for pieces of the same weight.
SAMPLE
888.8.8.8 10
COUNT
WEIGHT UNIT WEIGHT
888 0.000 8
8
add 000
Ж 10 Ж 5 Ж 25 Ж 50 Ж 100
888.8.8.8 50
WEIGHT UNIT WEIGHT
888 0.000 8
8
add 000
If weight isn’t zero, press the TARE.
SAMPLE
888.8.8.8 50
COUNT
WEIGHT UNIT WEIGHT
888 0.280 8
8
add 000
Ñ Blinking Ò
ENTER
8 -------
COUNT
WEIGHT UNIT WEIGHT
888 0.280 8
8
add 000
888.8.8.8 50
COUNT
WEIGHT UNIT WEIGHT
888 0.280 8
8
5.61200