A&D Weighing HC-3Ki - Manual (Page 14)

12
3-3. Unit Weight By a SAMPLE
10 Sample Size
1. The three UNIT WEIGHT BY LED’s should be blinking at this
point, if not, press the RESET key. to clear any unit weight. If you
are going to use a tare container, place it on the weighing pan.
2. Press the
SAMPLE key. Any tare
container will be automatically tared.
The display Will show “add” “10 pcs”.
3. Place l0 sample pieces on the
weighing pan (or in the tared
container).
The weight of all 10 pieces will
be displayed.
4. Press the
ENTER key.
The display will show “-------” for a
moment while calculating the unit
weight. After a moment the display will
show the count, total weight and unit
weight.
At this point the scale may decide that 10
pieces is not a large enough sample size for
accurate counting. If you see the “add ##” on
the unut weight display, then add the
additional number of sample pieces displayed.
‰ You can ignore the “add ##” message and
continue counting by pressing the ENTER
key. However, the results may not be accurate.
See F-Function f-01-02.
5. You may now begin counting operations for
pieces of the same weight.
‰ See “10. ACAI FUNCTION” for information
concerning the ACAI counting accuracy
function.
SAMPLE
888.8.8.8 10
COUNT
WEIGHT UNIT WEIGHT
888 0.000 8
8
add 000
ENTER
888.8.8.8 10
COUNT
WEIGHT UNIT WEIGHT
888 0.056 8
8
add 000
8 -------
COUNT
WEIGHT UNIT WEIGHT
888 0.056 8
8
add 000
888.8.8.8 10
COUNT
WEIGHT UNIT WEIGHT
888 0.056 8
8
5.61200
Total Weight Unit Weight
The weight of all The calculated
the sample pieces weight of a unit.
If weight isn’t zero, press the TARE.
888.8.8.8 10
COUNT
WEIGHT UNIT WEIGHT
SAMPLE
TOO LIGHT
HI LO OK
888. 0.004 8
8
add 8 15
Another 30 pieces