A&D Weighing GX-8000 - Manual (Page 56)

54
12. DATA MEMORY
Data memory is a function to store weighing data, calibration data and unit mass in memory. Of the
data in memory, the balance can only display the weighing data. The weighing data and calibration
data in memory are available for outputting at one time to a printer or personal computer.
One of the following data set can be stored:
Weighing data (Up to 200 sets. 100 sets when the time and date are added.)
Calibration and calibration test data (latest 50 sets)
Unit mass in the counting mode (Up to 20 sets)
12-1 Notes on Using Data Memory
To use the memory function, set the “Data memory ( data )” parameter of the function table. In
addition, for weighing data, set the “Time/Date output (5-td)” parameter. For details on setting the
data memory, refer to “10. FUNCTION TABLE”.
For weighing data, the data contents to be stored and the storage capacity depend on the
“Time/Date output (5-td)” parameter setting.
Releasing “Clr”
If a different type of data exists in memory when the data is stored, “Clr” appears blinking in the
upper left of the display. For example, you want to store weighing data but calibration data or unit
mass data remains in memory.
Under such a condition, before storing data, delete the data in memory as follows:
1 Press and hold the PRINT key until SClr no with “no” blinking is displayed.
2 Press the RE-ZERO key to display SClr go with “go” blinking.
The type of data stored in memory appears on the upper left of the display as shown below:
Unit mass in the counting mode PC
Weighing data without time and date -d-
Weighing data with time and date d-t
Calibration or calibration test data Hi5
3 Press the PRINT key to delete all the data in memory.
4 The balance displays end and returns to the weighing mode.