Installing the sr-700 series, Mounting the sr-700 series – KEYENCE SR-700 Series User Manual
Page 4
4
E SR-700-IM
Installing the SR-700 Series
Install the SR-700 Series as shown below to ensure reading stability.
Installation angle
The scanner of the SR-700 Series should be positioned at an angle of 15
°
in
relation to the 2D code or barcode surface when carrying out reading.
Point
Do not position the scanner to face directly at 2D codes or barcodes. Doing
so may cause instability in reading due to mirror reflection.
Adjusting the installation position and distance
1
Press the TUNE switch on the SR-700 Series. The laser pointer will
emit a laser beam.
Adjust the installation position and distance so that the laser pointer
intersection point and the center of the barcode line up.
The distance where the left
and right laser beams
intersect is the optimal
reading distance.
Adjust the laser pointer's
intersection point so that it
lies directly in the middle
of the 2D code or the
barcode.
Refer to the user's manual for tuning and confirming reading stability.
• The reading distance and angle differ depending on conditions such as
the size and the print quality of the 2D code or the barcode. Carry out
reading tests using the 2D code or barcode to be used and make
adjustments.
Mounting the SR-700 Series
Using the included mounting bracket
1
Attach the SR-700 Series to the mounting bracket.
Secure the mounting bracket with the included M3 screws.
2
Secure the mounting bracket to the device.
Secure the mounting bracket to the device using the installation screws,
purchased separately, with the included insulating spacers and washers.
The installation screws should be at least 3.7 mm (thickness of the
bracket, washer, etc.) + 3 mm long.
Reading distance
15°
Reading distance
20° or more
15° or more
Focal
distance
• Make sure to attach the included insulating spacers to prevent excessive
noise from the device.
• Reading errors may occur if the insulating spacers are not attached.
Included
installation screws
M3 x2
Mounting
bracket
Mounting
bracket
Installation
screw (M4)
Washer
Insulating
spacer
NOTICE