Hardy HI 1746-WS - Manual (Page 12)

HI 1746-WS WEIGH SCALE MODULE
1-2
should understand process control and be able to
interpret ladder logic instructions necessary to gener-
ate the electronic signals that control your applica-
tion(s).
About Hardy Manuals Every Hardy Installation and Operation manual is
organized into easily referenced chapters, that are
almost always the same:
•
Chapter 1 - Provides an introduction to the
instrument and an Overview of the equipment
and its capabilities.
• Chapter 2 - Provides a complete list of Specifi-
cations.
• Chapter 3 - Contains information needed to
install the HI 1746-WS (both standard and
optional equipment) and the HI 215IT series
Junction Box.
• Chapter 4 - Provides complete hardware Con-
figuration instructions for setting dip switches
and jumpers.
• Chapter 5 - Pertains to the firmware/software
Setup and preparation procedures to calibrate
and operate the instrument.
• Chapter 6 - Provides all Calibration instruc-
tions.
• Chapter 7 - Pertains to the Operating Proce-
dures of the HI 1746-WS.
• Chapter 8 - Pertains to the Troubleshooting
procedures for repair of the instrument.
Hardy Process Solutions hopes that this manual meets
your needs for information and operation. All correc-
tions or suggestions for improvements of this manual
are welcome and can be sent to the Technical Publica-
tions Department or Customer Support Department at
Hardy Process Solutions Inc.
Description The HI 1746-WS Weigh Scale Module is a self con-
tained microprocessor based I/O module with control
inputs and outputs, that is designed to be easily
plugged into the back plane of an Allen-Bradley SLC
5/02, 5/03, 5/04 or 5/05 programmable controller and/
or Remote Rack. The HI 1746-WS Weigh Scale Mod-
ule can be configured to operate as either a local or