2 removing the plunger (23), 4 collecting vessel, 2 removing the plunger (23) 7.4 collecting vessel – FRITSCH PULVERISETTE 19 User Manual
Page 45: Cleaning
7.3.2.2
Removing the plunger (23)
1.
Open the funnel lid (21).
2.
Unscrew the cross-head screws (D) with a screwdriver.
3.
Close the funnel lid (21).
4.
Unscrew the Torx screws (E) with a screwdriver.
5.
Unscrew the knurled screw (B).
6.
The plunger (23) can be taken out.
7.
Install in reverse order.
7.4 Collecting vessel
Pull out the collecting vessel (8) and clean it. It can be vacuumed or
wiped down with a damp cloth.
NOTICE!
Close the cutting mill after cleaning and check for proper
functioning. See Ä Chapter 5 ‘Initial start‐up’ on page 25.
NOTICE!
Make sure that the parts sit firmly when assembling.
Cleaning
- 45 -