FRITSCH PULVERISETTE 19 - Manual (Page 29)

6.1.2 Inserting / changing the fixed knives
1. Open the cutting mill (see Ä Chapter 6.1.1 ‘Opening the cutting
mill’ on page 28)
2. When inserting or changing the fixed knives (4, 5, 9) the rotor (3)
and the sieve cassette (7) must be removed (see Ä Chapter 6.1.4
‘Inserting / changing a rotor’ on page 31 and Ä Chapter 6.1.5
‘Inserting / changing a sieve cassette’ on page 33).
3. Loosen the retaining screws (A) to change or remove the fixed
knives (4, 5, 9).
4. When inserting, fasten the fixed knives (4, 5, 9) with the retaining
screw (A).
5. After mounting the rotor (3) (see Ä Chapter 6.1.4 ‘Inserting /
changing a rotor’ on page 31) set the gap width of the knives (see
Ä Chapter 6.1.3 ‘Setting the gap width of the knives’ on page 30).
6.1.2.1 Installation position of the fixed knives
(9) Fixed knife 2
(4) Fixed knife 1
(5) Fixed knife 2
Using the device
- 29 -