FRITSCH PULVERISETTE 19 - Manual (Page 4)

Table of contents
1 Basic structure............................................................................... 7
2 Safety information and use........................................................... 9
2.1 Requirements for the user..................................................... 9
2.2 Scope of application............................................................... 9
2.2.1 Operating principle........................................................... 10
2.3 Obligations of the operator................................................. 10
2.4 Information on hazards and symbols used in this manual. . 11
2.5 Device safety information.................................................... 13
2.6 Protective equipment.......................................................... 15
2.6.1 Opening the cutting mill without mains connection........ 15
2.7 Hazardous points................................................................. 16
2.8 Electrical safety.................................................................... 17
2.8.1 General information......................................................... 17
2.8.2 Protection against restart................................................. 17
2.8.3 Direction of rotation detection......................................... 17
2.8.4 Overload protection.......................................................... 17
3 Technical data.............................................................................. 18
3.1 Dimensions.......................................................................... 18
3.2 Weight.................................................................................. 18
3.3 Operating noise.................................................................... 18
3.4 Voltage................................................................................. 18
3.5 Current consumption........................................................... 18
3.6 Power consumption............................................................. 18
3.7 Motor shaft power in accordance with VDE 0530, EN
60034................................................................................... 19
3.8 Electrical fuses..................................................................... 19
3.9 Material................................................................................ 19
3.10 Final fineness..................................................................... 19
3.11 Speed................................................................................. 19
4 Installation................................................................................... 20
4.1 Transport............................................................................. 20
4.2 Unpacking............................................................................ 20
4.3 Setting up............................................................................. 20
4.4 Ambient conditions.............................................................. 20
4.5 Fastening the Universal Cutting Mill.................................... 21
4.6 Selecting and converting the funnels................................... 21
4.6.1 Selecting the funnel.......................................................... 21
4.6.2 Converting from standard funnel to protected funnel..... 22
4.6.3 Converting from protected funnel to standard funnel..... 22
4.7 Electrical connection............................................................ 23
Table of contents
- 4 -