FRITSCH PULVERISETTE 19 - Manual (Page 16)

3. At this time, it is not possible to switch on the Universal Cutting
Mill. To switch it on, the safety lock (11) must be activated by
turning the triangular key to the left, the closing lid (6) must be
closed and the latch clamp (13) in locked position.
2.7 Hazardous points
n The closing lid (6) can be lifted out of the hinges. When opening the
upper part of the housing (2) it is possible to leave the closing lid (6)
in the hinge. If this is the case, ensure that the closing lid (6) does
not lift out of the hinge when opening the upper part of the housing
(2).
n When opening the upper part of the housing (2), there is an initial
resistance.
n Make sure that the closing lid (6) is fully open!
n When opening the upper part of the housing (2), slowly swivel it
open until the upper part of the housing (2) is resting on the rubber
buffer - do not let it fall down heavily.
n Crushing hazard when closing the upper part of the housing (2).
Close it slowly!
Safety information and use
- 16 -