FRITSCH PULVERISETTE 19 - Manual (Page 23)

3. Switch the control switch (19) on the back of the device to 0.
4. Remove the mains plug (20).
5. Unscrew the four M6x12 hexagon bolts fastening the protected
funnel (22) to the upper part of the housing (2) using a hexagon
socket screw key and lift off the protected funnel (22).
6. Insert the standard funnel (1) and fasten it with the four M6x12
hexagon bolts and the washers.
7. Connect the device again to the mains.
8. Switch the control switch (19) on the back of the device to AUTO.
ð The device is ready for operation.
4.7 Electrical connection
Before establishing the connection, compare the voltage and current
values stated on the type plate with the values of the mains system to be
used.
(see Ä Chapter 3 ‘Technical data’ on page 18).
Installation
- 23 -