FRITSCH PULVERISETTE 7 premium line User Manual
Operating instructions, Planetary micro mill
Table of contents
Document Outline
- Table of contents
- 1 Safety information and use
- 2 Technical data
- 3 Installation
- 4 Initial start-up
- 5 Using the device
- 5.1 Safety information
- 5.2 Choice of grinding bowls and grinding balls
- 5.3 Impact of the ball size and the material during grinding
- 5.4 Filling quantities of grinding bowls
- 5.5 Filling the grinding bowl
- 5.6 Factors with an impact on grinding
- 5.7 Dry grinding
- 5.8 Wet grinding (grinding in a suspension)
- 5.9 Handling the grinding bowl
- 5.10 Mass balance
- 5.11 Grinding duration
- 5.12 Conducting a grinding operation
- 6 Accessories
- 6.1 Standard gassing lid for grinding with inert gas
- 6.2 Gassing lid with stainless steel, swagelok hose couplings
- 6.3 EASY GTM Gas Pressure and Temperature Measuring System
- 6.3.1 Case contents and system design
- 6.3.2 Inserting / changing the battery
- 6.3.3 Configuration of transmitter ID and data transmission frequency
- 6.3.4 Installation of the transmission unit on the EASY GTM bowl
- 6.3.5 Installation of the receiver board in the P-7 premium line
- 6.3.6 Activating EASY GTM
- 6.3.7 Entering the temperature limit
- 6.3.8 Entering the pressure limit
- 6.3.9 Selecting the operating mode
- 6.3.10 Deactivating EASY GTM
- 6.3.11 Cleaning the EASY GTM system
- 6.3.12 Battery arrangement
- 6.4 Special emptying device for grinding bowls
- 6.5 Compl. counterweight
- 6.6 Planetary mills - "MillControl" software
- 7 General and optional settings
- 8 Cleaning
- 9 Maintenance
- 10 Guarantee terms
- 11 Exclusion of liability
- 12 Safety logbook
- 13 Index