FRITSCH PULVERISETTE 19 - Manual (Page 21)

4.5 Fastening the Universal Cutting Mill
Screw the cutting mill tightly to the stand provided (acc. to instructions)
or to a stable mount (table...). The following must be observed in order
to fasten the device:
n Unscrew the 3 screws fastening the motor cover (14).
n Lift the motor cover (14) off carefully.
n Two U-profiles (12) are mounted on the bottom of the device. Insert
the 4 screws provided through the bore holes in the U-profiles (12)
and screw them tightly to the stand or table. Other screws with the
same diameter can also be used.
WARNING!
Ensure that the device is safely fastened. Sizeable lateral
forces can occur!
NOTICE!
Make sure that the Universal Cutting Mill is easily acces-
sible. On the right of the mill there must be enough space
to lift open the upper part of the housing (2) incl. funnel (1,
22).
Keep the ventilation grate (18) on the back free. Risk of
overheating!
4.6 Selecting and converting the funnels
4.6.1 Selecting the funnel
The standard funnel (1) is used for long and bulk solids, for free-flowing
material, but also for the comminution of long goods, like for example
straw or wood. The protected funnel (22) is used for all other materials.
Installation
- 21 -