FRITSCH PULVERISETTE 19 - Manual (Page 42)

7 Cleaning
7.1 Housing
The cutting mill can be wiped down with a damp cloth when it is
switched off. Disconnect the mains plug (20) from the electricity.
DANGER!
Do not allow any liquids to flow into the device.
7.2 Cutting chamber
Clean the cutting chamber with a dust exhaust system and brush and
also with compressed air, if necessary.
CAUTION!
Beware of dust exposure caused by cleaning with com-
pressed air!
CAUTION!
Risk of entrapment!
When the control switch is at the "HAND" position, the
rotor can be turned freely in both directions!
1. Switch the control switch (19) on the back of the device to HAND.
2. Unlock the latch clamp (13).
3. Open the closing lid (6) fully. This can be lifted out of the hinge at
an opening angle of 90° for cleaning.
Cleaning
- 42 -