FRITSCH PULVERISETTE 7 premium line - Manual (Page 78)

2. The PKM interfaces board (81.0011.00) is on the rear panel, with
the slot (f) for the receiver module 81.0013.00.
3. Insert the receiver module in the corresponding slot. (As illus-
trated)
4. Close the rear panel of the housing again and screw it tight.
6.3.6 Activating EASY GTM
If the device is protected by SOP mode (Ä Chapter 7.1 ‘Standard Opera‐
tion Procedure’ on page 92), please contact the PULVERISETTE-7 admin-
istrator. This mode must be deactivated, otherwise only programs
already stored can be loaded for operation.
To activate the EASY GTM system, proceed as follows:
Accessories
- 78 -