FRITSCH PULVERISETTE 7 premium line - Manual (Page 77)

5. Switch on the transmitter with the On/Off button (A) and insert
the bowl as described in Ä Chapter 5.9.4 ‘Inserting the grinding
bowl in the grinding bowl holder’ on page 44!
NOTICE!
Check the fitting of the transmission unit again after
inserting the bowl!
NOTICE!
During a grinding, during the pauses, the correct
position of the Allen screws of the transmission unit
must to be checked. If screws became loose, re-
tighten them.
6.3.5 Installation of the receiver board in the P-7 premium line
DANGER!
Before starting the installation, disconnect the mains plug
and protect the device against being unintentionally
switched back on.
Secure installation work with a warning sign.
1. The 6 screws (e) used to attach the rear panel to the housing are
undone and the rear panel is opened carefully.
Accessories
- 77 -