FRITSCH PULVERISETTE 7 premium line - Manual (Page 73)

5. Undo the two screws (D) of the battery compartment using a hex-
agon offset screwdriver, size 2.5mm (6).
6. Lift off the battery compartment lid and place it to the side. The
battery compartment can be seen.
NOTICE!
Please note that the the battery (2) fits exactly in place and
may need to be pushed in using a certain amount of force.
The service life of the battery (2) depends on the frequency
of the radio protocols (see configuration) and essentially on
the temperature inside the grinding bowl.
Also pay attention to the battery's charge level. If the bat-
tery's capacity falls below 10%, it should be replaced imme-
diately.
7. Remove the old battery and insert the new battery (2). Battery
type: 1.5V / AA
When inserting the battery pay attention to the
polarity!
8. Close the battery compartment! Make sure the plug contacts are
in the correct position!
Accessories
- 73 -