Aviom 6416o - Manual (Page 54)

45 o
PerAtiNg
s
Ystem
u
PdAte
new firmware. Send the firmware update following the instructions that
came with the update firmware. During the update, the module’s sixteen
red, yellow, and green channel meter LEDs will flash in sequence. When the
firmware update has been sent successfully, the module will reset and audio
will be restored.
When a module is being updated via A‑Net in an active network, the dot in
the A‑Net Slot display will be on, indicating that a network firmware update
is in progress.
When a module is waiting for a firmware update to begin, you can exit the
firmware update state by pressing the C
anCEl
button. If the firmware update
has not yet started, the module will attempt to reset, returning it to normal
operation.
 N
ote
: Do not press the C
anCEl
button or exit the Pro64 Update Tool
application while a firmware code update is in progress.
Restore Factory Defaults
Function 16 restores the Pro64 module to its factory default settings.
To restore the factory default settings, press F
unCtion
followed by the C
hannEl
16 a
CtivE
button. The Enter/Cancel LED and the sixteen red channel level
LEDs will flash, indicating that this function will interrupt normal network
operation. Press E
ntEr
to continue and recall the factory default settings, or
press C
anCEl
to exit, leaving the current settings in place.
The Factory Default settings are:
A‑Net Slot is set to 1. •
Auto Mode is selected. •
• Sample Rate is set to 48kHz.
All audio channels are muted and deactivated for • Auto,
Manual, and Managed Modes.
All stereo links are deactivated for Auto, Manual, and
•
Managed Modes.
Managed Mode is deactivated.
•
• Edit Lock is set to off.
• Password protect is off.
The system • password value for the module being reset is
“1‑1‑1‑1.”
All Virtual Data Cables are deactivated.
•
The Clock Master and Control Master settings are hardware controlled and
dependent upon the rear‑panel DIP switch settings. These are not changed
when factory defaults are restored.