360 Systems TCR Multi-Track - Manual (Page 62)

4-12 Operations TCR Series UserManual
Press RECALL button to present the Recall Locate Point Prompt, which allows you to recall a
value from a locate point and place it in the LOC Register. You can also recall special time code
points as mentioned above.
Locating
Press LOCATE to instantly cue to the time code currently shown in the LOC Register. To cue to a
specific time code, enter the value in the LOC Register using one of the above methods and press
LOCATE.
The LOCATE button can also be used as a transport control. When LOCATE is pressed during play
or shuttle modes, for example, the transport immediately cues to the value in the LOC Register.
Naming Locates
Each file has 100 locate points, each of which can be named using the Name Locates function — to
serve as notes, or simply to assist in easily spotting the desired locate point in the list.
[Transport Screen] | MENU | Name Locates
From the Transport Screen, press MENU, select item 1, NAME LOCATES, to display the locate
points for the current file. Use the Jog Wheel to highlight the locate point that you want to name,
then press ENTER. The Name Locate Prompt is then displayed allowing you to enter the new
offset name using the keypad.
NAME LOCATE POINT
ENTER NEW NAME
¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯
ENTER = DONE
EXIT = CANCEL
EDIT IN = DELETE
EDIT OUT = INSERT
UNDO = UNDO CHANGES
Name Locate Point Prompt
Review Playback
The REVIEW button provides a way to play a selected portion of the file. It is normally used after a
punch-in or an auto record operation to hear the result of the recording.
Edit Points
The Edit-In and Edit-Out points define the range of audio played during a review. When REVIEW is
pressed, the transport cues to the Edit-In point minus the configured pre-roll duration and begins
playback. Playback continues to the Edit-Out point plus the configured post-roll duration. Edit-In
and Edit-Out points are typically set manually prior to performing an auto record or a preview. Edit-
In and Edit-Out points are set automatically during a punch-in recording. They can also be set by
STORING the contents of the Locate Register directly to Edit-In or Edit-Out.