Panasonic CT-36VG50 - Manual (Page 43)

Set Up Features
Setting PC Mode Set Up Features will also change
TV Mode and DTV Mode Set Up Features.
Auto Power On
— This feature automatically turns
the monitor ON when AC power is applied.
1 .
2. Press ^ or ^ and or ^ to select the Set Up
Icon.
3. Press I to display the Set Up menu.
NOTE: Setting the Auto Power On feature will cancel the
time and timer control settings. Also, the TV Mode Main
Menu Icon for the Timer Control will be replaced with an
Exit icon.
4. Press ^ or ^ to highlight AUTO POWER ON.
5. ^Press or ^ to select SET.
6. Press twice to exit menus.
Geomagnetic Corr (Correction)
This monitor incorporates a special adjustment feature for
the convenience of the customer. This adjustment is preset
at the factory. However, adjustment may be required when
the monitor is moved (due to the influence of earth’s
magnetic field) which may cause the picture to tilt slightly. If
necessary, follow these procedures to adjust the tilt.
1. Press
2. Press ^orW and or ^ to highlight the Set Up
to display the Set Up Menu.
5. Press ^ or^ to display the Geomagnetic Correction
adjustment menu.
tilt adjustment bar
6. Press or to adjust the picture tilt until left and
right side of tilt adjustment bar is parallel to the bottom
of picture frame (if necessary).
NOTE: Discoloration may be visible in picture comers
if tilt bar is not parallel to the bottom of picture
frame.
7. Press (^3 twice to exit merius.
Input Select
This feature is used to select PC Input Front or PC Input
Rear for the monitor Input signals.
1. Press
2. Press or^^ and or to highlight the Input
Select Icon.
3. Press ^3) to display the Input Select Menu.
4.
NOTE: PC Front or PC Rear can also be selected by
pressing the Input button while Input Select menu
is displayed.
5. Press ^3 twice to exit menus.
4. Press A or W to highlight GEOMAGNETIC CORR.
-
42
-