Panasonic CT-36VG50 - Manual (Page 25)

Auto Program
The Auto Programming feature allows you to place
channels with a video signal into Channel Scan Memory.
When you press ^ or only those channels with a
video signal will accessed. TV or Cable Tuning mode
must be set properly for your system.
Set Up Features (cont’d.)
1 .
2. Press ^ or Wand‘s or ^ to highlight the Set Up
Icon.
3. Press to display the Set Up menu.
4. Press ^ or W to highlight AUTO PROGRAM.
5. Press ^ or ^ to start Auto Programming Scan.
, Channels will automatically advance until all channels
have been scanned.
• Channel numbers with video signal present will turn
blue which indicates stored in Channel Scan Memory.
6. Press twice to exit menus.
NOTE:
Some channels with very weak signals may be
locked into memory. These must be deleted
manually using the Manual Program feature.
Manual Program
This feature allows you to select which channels are
placed into Channel Scan Memory so when you
press ^ or ^ only those channels you desire will be
accessed.
1. Press the .
2. Press ^ or W and ^ or ^ to highlight the Set Up
Icon.
-3- Press fl^^ltQ.djspiay-t.hcSGt-iJprngnu.------------------------------
SETUP PETiUm
rWIANUAL PROGRAM
ONIM
MODE
4. Press A or ^ to highlight MANUAL PROGRAM.
5. Press ^ or ^ to display Manual. Programming
Menu.
6 .
7.
8
.
Use the Remote Control Keypad numbers “0 through
9” or A or W to select channels. .
Press ^ to add channel(s) to memory (blue). Press
the to delete channel(s) from memory (yellow).
Repeat Steps 6 and 7 to continue adding or deleting
channels.
9. Press I twice to exit menus.
-
24
-