Panasonic CT-36VG50 - Manual (Page 24)

Geomagnetic Corr (Correction)
This monitor incorporates a speciai adjustment feature for
the convenience of the customer. This adjustment is preset
at the factory. However, adjustment may be required when
the monitor is moved (due to the infiuence of earth’s
magnetic fieid) which may cause the picture to titt stightiy. If
necessary, follow these procedures to adjust the tilt.
Set Up Features (cont’d.)
1. Press
2. Press ^^or^^ and*^or^ to highlight the Set Up
3. to display the Set Up menu.
Press A or W to highlight GEOMAGNETIC CORR.
Press ^ or^ to display the Geomagnetic Correction
adjustment menu.
Press‘d or ^ to adjust the picture tilt until left and
right side of tilt adjustment bar is parallel to the bottom
of picture frame (if necessary).
NOTE: Discoloration may be visible in picture comers
.
if tilt bar is not parallel to the bottom of picture
' frame.
6 .
Mode
IMPORTANT NOTE: The proper input mode must be
selected for the type of signal at the antenna input.
• TV is used when the television is not connected to a
Cable TV System, for example, when using a VHF/UHF
antenna (Channels 02-69).
• CABLE is used when the television is connected to a
Cable TV System and when not using a Cable Box
(Channels 01-125).
NOTE: Some Cable TV Systems encode (scramble)
program materia) on specific channels. A cable
company supplied decoder is required to
reproduce an acceptable picture. Certain Cable
TV Systems offset some channels to reduce
interference. It will be necessary to use the cable
company supplied converter to receive these
specific channels.
1. Press ^i) ■
2. Press A or ^ and ^ or ^ to highlight the Set Up
Icon.
3. Press to display the Set Up menu.
4. Press A or W to highlight MODE.
5. Press or ^ to select TV or CABLE.
6. Press twice to exit menus.
-
23
-